WLtoys 1:24 car A232 brushless motor 2030+18A

1, the product is suitable for upgrading 1:24 remote control car (original motor is 180 motor), such as WLtoys 1:24 car: A202, A212, A222, A232, A242, A252, also suitable for other brands of 1:24 remote control car;


2, Haoying EZRUN2030 motor has two KV options, 5200KV and 7800KV. Under 2S lithium battery condition, 5200KV motor torque ratio is large, 7800KV speed is faster, no matter which KV motor is selected, the speed exceeds 65KM/hour. Moreover, the torque and speed are greatly improved compared with the original car.


3. The power connector of the ESC has been changed to JST plug, which can be directly connected to the original battery;


4, 1:24 car modification and upgrade, need to change brushless motor and brushless ESC, we recommend using 2030 motor and Haoying 18A ESC, the linearity is particularly good, the start and speed are very violent, the servos can retain the original . After the upgrade, you need to replace the remote control. We strongly recommend using the AX5S three-channel remote control. In addition to the very good feel, this remote control can reach a distance of 200 meters, and the function of the limited speed position and the loss of control protection, in addition, The third channel can also be equipped with lights for your car.


Second, modification notes:


1. The original 180 has a brush motor, the motor screw is M2, and the screw hole of the 2030 motor is M2.5. Before installation, you need to enlarge the mounting hole of the motor seat, otherwise the screw of M2.5 is not easy to adjust. The clearance of the motor teeth;


2, special attention, Haoying EZRUN2030 motor shaft diameter officially marked is 2.0mm, the motor is the lower tolerance, the actual size will be smaller than 2.0, The solution is to stick the AB glue on the motor shaft and gear., this shop is available for sale.


3, the modification sequence: first remove the car shell - remove the second floor board - remove the original receiver - remove the motor seat - remove the gear (be careful not to hurt the gear when removing the gear) - remove the two screws of the motor - Remove the 180 motor and replace it with the original path. The process is very simple.